U型系列可調多軸器（重切削）產品介紹：
◎本體結構利用齒輪箱配合萬向節頭所組成，容易調整加工孔距不受齒輪所限制，節省調整的時間，也少有死角的限制。其齒輪、軸承、輸出軸、萬向節均采用強力系列，適合加工鋼件等強力場合。為保萬向節頭之壽命，移動范圍不得超過15度，等于垂直之前後左右30mm以內。
(盡量配合工作之孔距坐標，設計齒輪箱結構即定鏜孔位)
◎The basic frame consists of gear case and cardan joint.The hole-distance is easy to control and will not be affected by the gears.The set up time is thus saved and it is mostly free of dead angles.It is very suitable for working of round holes.
※萬向節注意事項：
1.調整時不能超過規定的角度15度
2.如超過此極限心軸易磨損或斷裂
3.工作時應經常加潤滑油脂
※Note of cardan Joint
1.Do not set the angle to more than the specifled l5 degrees.
2.If the limit is exceeded，the shaft will be easy to wear or break.
3.During work，lubrication should be added frequently.
|
型號 Type |
SWU165 |
SWU200 |
SWU250 |
SWU100×165 |
SWU120×200 |
SWU120×300 |
|
筒夾規格Collet/ *大鉆孔能力 Max.Drilling Capacity |
ER20/13 ER25/16 |
ER20/13 ER25/16 |
ER20/13 ER25/16 |
ER20/13 ER25/16 |
ER20/13 ER25/16 |
ER20/13 ER25/16 |
|
轉速比 Gear Ratio |
1∶1 |
1∶1 |
1∶1 |
1∶1 |
1∶1 |
1∶1 |
|
*小距離（二軸間） Lowest Distance(Two Spindle) |
42 |
42 |
42 |
42 |
42 |
42 |
|
*大軸心范圍 Max.Range of Centers |
165 |
200 |
250 |
100×165 |
120×200 |
120×300 |
|
軸數 Spindle |
2-10 |
4-12 |
4-12 |
3-8 |
4-12 |
6-14 |
